Installing The Canopy Housing; Assembling And Mounting The Fan Blades - Fanimation The Keistone FPD8088-NL Serie Manual Del Propietário

NOTE: This step is applicable after the necessary wiring
is completed.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)

Assembling and Mounting the Fan Blades

Assembling and Mounting the Fan Blades
1. Remove and discard the five rubber motor stops
from the motor assembly by removing the screws.
(Figure 1)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade arm.
With a phillips screwdriver, tighten 3/16-24 x 7.5 mm
washer head screws and fiber washers to secure the
blade to the blade arm. (Figure 2)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.

Installing the Canopy Housing

Blade
HARDWARE USED:
3/16-24 x 7.5 mm
WASHER HEAD
SCREWS
FIBER WASHER
10
Figure 1
Figure 2
Figure 1
Blade Holder Arm
Figure 2
x 15
x 15