How To Mount The Fan Blades - Fanimation MA7966 Serie Manual Del Propietário

1. To adjust the vertical alignment of the belt, loosen the
screw in the pulley assembly pulley with the supplied by
allen wrench to adjust the pulley so that belt is parallel
with the floor, then securely tighten the screw. (Figure 1)
2. Remove the end cap from the pulley assembly.
Retain the end cap for later. (Figure 2)
3. Securely fasten the two blades (not included) with
washer-head screws with fiber washers. Do not
over-tighten. (Figure 3)
CAUTION
Do not connect fan blades until the fan is completely
installed. Hanging fan with blades connected may result
in damage to the fan blades.
NOTE: Optional Wood Blade Set B7966** is available for
this assembly. Not for Damp Location usage.
4.
Assemble the end cap to the
by twisting in a clockwise direction.

How to Mount the Fan Blades

pulley assembly
(Figure 4)
Pulley
Assembly
HARDWARE USED:
ALLEN
WRENCH
6 x 90 x 32 mm
Pulley
Assembly
HARDWARE USED:
3/16 -24
WASHER HEAD
SCREWS
FIBER WASHER
13
Motor
Assembly
Belt
Allen Wrench
Figure 1
Pulley
Assembly
Figure 2
3/16 -24 Screws
(3 per assembly)
Figure 3
x 6
x 6
Figure 4
Blade