Microlife WatchBP office Manual De Instrucciones página 31

Software commands
Choose measure blood pressure
Enter Patient ID
Start to perform
Store blood pressure measurements Click «Save». The data is stored in an Excel data table. The file
View the data
Print the data sheet
Disconnect the device
Close the program
The software automatically searches for the nearest WatchBP device when the program is launched. If the device is
*
not located, confirm that the Bluetooth switch on the WatchBP Office is set to the ON position.
Click «1st VISIT», «FOLLOW-UP »
Input Patient ID
Press the «Measure» button
name is generated automatically from the following format
«Patient ID+ WatchBP Office +measurement mode +
yyyymmdd.xls».
Go to the folder where the file is saved and open the
corresponding Excel file.
While the corresponding Excel file is open, click print in Excel.
Click «Disconnect» before existing the program
Click «Close»
33
EN