Connecting Speakers; Important - JVC UX-P30 Manual De Instrucciones

Sistema de micro componentes
Ocultar thumbs Ver también para UX-P30:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

AM antenna
]
ANTENNA
1
AM EXT
AM LOOP
FM
COAXIAL
2
AM loop antenna
(supplied)
1
Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
2
Turn the AM loop antenna until you have
the best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
7
]
Vinyl-covered wire
(not supplied)
75

Connecting Speakers

1
RIGHT
MAIN
SPEAKERS
Speaker
SPEAKER
cord
IMPEDANCE
MIN 4
Right speaker
1
Press and hold the clamp of the speaker
terminal on the rear of the unit.
2
Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red ª to
red ª and black · to black ·.
• If the cords are covered with insulation,
remove a short section of insulation at
the end of each cord by twisting and
pulling it off.
3
Release the finger from the clamp.
• DO NOT connect speakers while the power is
on.
• DO NOT connect more than one speaker to each
speaker teminal.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
3
2
Red
LEFT
Speaker
cord
Black
Left speaker

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ca-uxp30Sp-uxp30

Tabla de contenido