Playing Back Tapes; Playing Back A Tape - JVC UX-P30 Manual De Instrucciones

Playing Back Tapes

You can play back type I tapes.

Playing Back a Tape

1
Press ) on the unit.
2
Put a cassette in with the exposed part of the
tape down.
3
Close the cassette holder gently.
4
Press TAPE 2 3.
The unit automatically turns on and the tape
play starts. The tape direction indicator
(3 or 2) flashes slowly on the display.
• Each time you press the button, the tape direction
changes.
3 : plays the front side.
2 : plays the reverse side.
When the tape plays to the end, the deck automatically
stops if the reverse mode is set to
play both sides—Reverse Mode.")
To stop playing, press 7.
To fast-wind to the left or to the right,
press ¢ or 4 while the tape is not
running.
The tape direction indicator (3 or 2) starts
flashing quickly on the display.
To remove the cassette, press ) on the unit.
To play both sides—Reverse Mode
You can set the deck to play just one side of a tape, both sides
once, or both sides continuously.
On the unit ONLY:
Press REV.MODE.
• Each time you press the button, reverse mode
changes as follows:
:
TAPE
or . (See "To
: The deck automatically stops after playing both
sides of the tape. (Stops when playback in the 2
direction is finished.)
: The deck continues to play both sides of the tape
until 7 is pressed.
The deck automatically stops after playing one
side of the tape.
The use of the C-120 or longer tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.
REV.MODE
16