Listening To Fm And Am Broadcasts; Tuning In A Station; Presetting Stations - JVC UX-P30 Manual De Instrucciones

Sistema de micro componentes
Ocultar thumbs Ver también para UX-P30:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Listening to FM and AM Broadcasts

Tuning in a Station

1
Press FM/AM.
The unit automatically turns on and
tunes in the previously tuned
station—either FM or AM.
• Each time you press the button, the band alternates
between FM and AM.
2
Press and hold ¢ or 4
for more than 1 second.
The unit starts searching for stations
and stops when a station of
sufficient signal strength is tuned in.
If a program is broadcasted in stereo, the ST (stereo)
indicator lights up.
To stop searching, press ¢ or 4.
When you press ¢ or 4 briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to
receive or noisy, press FM MODE on the
remote control so that the MONO indicator
lights up on the display. Reception improves.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off. In this stereo mode, you can
hear stereo sounds when a program is broadcasted.
11

Presetting Stations

You can preset 30 FM and 15 AM stations—using either
FM/AM
automatic presetting or manual presetting.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
To preset stations automatically—Automatic Presetting
You need to preset stations separately for the FM and AM
bands.
On the remote control ONLY:
1
Press FM/AM to select the band.
The unit automatically turns on and tunes
in the previously tuned station—either FM
or AM.
• Each time you press the button, the band
alternates between FM and AM.
2
Press and hold AUTO PRESET
for more than 2 seconds.
FM MODE
Local stations with strong signals are
searched and stored in memory automatically.
When automatic presetting is over, the station stored in
preset number 1 is received.
3
Repeat steps 1 and 2 to store stations for the
other band.
When you cannot automatically store stations you want
Stations with weak signals cannot be detected with this automatic
presetting. To store such a station, use the manual presetting.
FM/AM
AUTO
PRESET

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ca-uxp30Sp-uxp30

Tabla de contenido