Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Common Operations
Turning On the Power
When you press the play button—CD 3/8, TAPE 2 3 or
the source selecting button—FM/AM and AUX, the unit
automatically turns on and starts playback if the source is
ready.
To turn on the unit, press STANDBY/ON
unit).
The STANDBY lamp on the unit goes out.
STANDBY/ON
To turn off the unit (on standby), press STANDBY/ON
(or
on the unit) again.
The STANDBY lamp lights up.
• The CLOCK indicator flashes on the display until you set
the built-in clock. After setting the clock, the clock time
will appear on the display while the power is off.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "0:00" right away, while the tuner preset
stations (see page 11) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. When you plug the AC power cord into the wall
outlet, the CLOCK indicator starts flashing on the display.
You can set the clock when the unit is either turned on or in
standby mode.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Press CLOCK for more than 2
seconds.
The hour digits start flashing on the display.
CLOCK
9
(or
on the
STANDBY
CLOCK
2
Press ¢ or 4 to
adjust the hour, then
press CLOCK.
The minute digits start flashing
on the display.
CLOCK
3
Press ¢ or 4 to
adjust the minute, then
press CLOCK.
The CLOCK indicator remains
lit on the display.
CLOCK
To check the clock time
Press DISPLAY (or CLOCK on the unit) while
playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
• When you unplug the AC power cord or if a power failure occurs,
the clock loses the setting and is reset to "0:00." You need to set
the clock again.
• The clock may gain or lose 1 to 2 minutes per month.
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing. When shipped, the built-in AM
tuner is set to 9 kHz spacing.
You can change it to 9 kHz or 10 kHz spacing only while the
unit is on standby.
On the unit ONLY:
To select 10 kHz intervals,
while holding ¢.
press
To select 9 kHz intervals,
while holding 4.
press
When you change the setting
The preset stations are erased. You will need to preset the stations
again. (See page 11.)
7
4
¢
CLOCK
7
4
¢
CLOCK
DISPLAY
CLOCK
7
4
¢
STANDBY
Publicidad
Capítulos
Tabla de contenido
