Adjusting The Height Of The Headrest; Adjusting The Reclining Position - CASUALPLAY WAVE Manual De Instrucciones

Instructions for use

ADJUSTING THE HEIGHT OF THE HEADREST

• The harness straps should both be at the same height. Adjust the height
of the harness by altering the height of the headrest.
• Loosen the harness as far as it will go. To do this, press the harness
adjustment button while pulling the straps with your other hand (fig.1).
• Unlock the headrest adjuster, found on the back of the backrest (fig.2).
• Place the headrest at the required height (fig.3-4), and lock the adjuster
(fig.5).

ADJUSTING THE RECLINING POSITION

• The seat has three reclining positions.
• Pull the front lever at the bottom and keep it activated.
• Push the backrest to the required position and release the lever (fig.6).
NOTE: Make sure that the backrest is not midway between two positions.
INSTALLING IN THE VEHICLE (GROUP 1, 9-18 KG)
INSTALLING THE SAfETy SEAT wITH THE SEAT BELT
• Place the safety seat on the vehicle seat, press the child restraint
system, leaning against the front of it, against the vehicle seat (fig.7).
• Take hold of the end of the seat belt (fig.8), and pass it between the
backrest and the frame. The diagonal part should go through the locking
clip, and the abdominal part through the guides (fig.9).
• Fasten the seat belt buckle.
• At the end of the seat belt buckle, pass both sections of the seat belt
through the guide.
• Tighten the seat belt and close the locking clip.
• Loosen the safety harness. Press the harness adjustment button while
pulling the harness (fig.1).
• Unfasten the harness buckle and separate the two sides (fig.10).
• Place the child in the restraint system.
• Adjust the height of the headrest and fit the harness on the child at the
correct height.
• Fasten the harness by bringing the two parts of the chest straps together
and inserting them in the female part of the buckle. Then press both
until they click fastened (fig.11).
16