Glomex PANDORA V8000 Manual Del Usuario E Instalación página 49

Instructions for V9330
8. Position the antenna onto the seal, and firstly
insert the cable through the relevant hole, then
the 4 threaded bars, and pay attention to direct
the orientation symbol of the antenna towards
the bow.
Fig. 10
9. Install the fastening reinforcements onto the
threaded bars and screw in the M8 self-locking
nuts.
Fig. 11
10. Completely tighten.
S
WARNING
GLOMEX declines any liability for an incorrect
mounting of the radome on the boat.
11. Connect the 10 m coaxial cable to the cable
coming out of the antenna.
Should it be necessary to shorten the cable,
please refer to the instructions given in Fig. 12.
www.glomex.it
PANDORA V8000 - URANIA 2 V9330
Fig. 12
S
WARNING
Do not pull nor damage the cable coming out of the
antenna! It is not provided with an outer sheath as
the 10 m coaxial cable!
12. Make sure that the cable core is correctly
inserted in the central hole of the female
connector on the antenna (otherwise, there
could be a short circuit and the fuse installed on
the power supply line inside the control unit
would trip).
Manually screw in the ring nut of connector F.
Once the ring nut has been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench.
13. Remove the two safety straps found on the
azimuth and lifting gears.
47
GL00095