Dell Networking S3048 Guía De Inicio página 12

Figure 3. Two-Post Center-Mount Configuration
Four-Post Threaded Configuration
To install the Dell ReadyRails system using the four-post threaded
configuration, follow these steps.
1. For this configuration, remove the flange ear castings from each end of
the ReadyRails assemblies. Use a Torx driver to remove the two screws
from each flange ear and remove each casting. Refer to item 1 of the
following figure. Retain the castings for future rack requirements.
2. For each rail, attach the front and rear flanges to the post flanges with
two user-supplied screws at each end. Refer to item 2 of the following
figure.
10