Rack Mount The Switch; Installing The Dell Readyrails System - Dell Networking S3048 Guía De Inicio

NOTE: These instructions are a condensed reference. Read the safety
instructions in your Safety, Environmental, and Regulatory information
booklet before you begin.
NOTE: The illustrations in this document are not intended to represent a
specific switch.

Rack Mount the Switch

You may either place the switch on a rack shelf or mount the switch directly
into a 19" wide, EIA-310-E-compliant rack (four-post, two-post, or threaded
methods).
The Dell ReadyRails™ system is provided for 1U front-rack and two-post
installations. The ReadyRails system includes two separately packaged rail
assemblies and two rails that are shipped attached to the sides of the switch.
WARNING: This is a condensed reference. Read the safety instructions
in your Safety, Environmental, and Regulatory information booklet
before you begin.
CAUTION: Do not use the mounted Ready-Rails as a shelf or a
workplace.
NOTE: The illustrations in this document are not intended to represent a
specific switch.

Installing the Dell ReadyRails System

The ReadyRails rack mounting system is provided to easily configure your
rack so that you can install your switch.
Install the ReadyRails system using the 1U tool-less method or one of three
possible 1U tooled methods (two-post flush mount, two-post center mount,
or four-post threaded).
1U Tool-less Configuration (Four-Post Square Hole or
Unthreaded Round Hole)
To install the Dell ReadyRails system using the 1U tool-less configuration,
follow these steps.
1. With the ReadyRails flange ears facing outward, place one rail between
the left and right vertical posts. Align and seat the rear flange rail pegs in
the rear vertical post flange. To see how the pegs appear in both the
7