Valve Controlled Griddles; Griddle/Broiler; Range Shut Down; Product Application Information - Garland G Serie Manual De Instalación Y Operación

OPERATION Continued

Valve Controlled Griddles

See griddle seasoning before use.
1. Pilots should be lit though the front panel with an extend
match. If necessary the front panel of the range can be
removed to allow the griddle plates to be raised at the
front, block securely.
2. Light pilots located at the front left side of each burner.
3. Turn burner valves completely on. Burners should have
1/2-inch to 5/8-inch, (13mm to 16mm), stable blue ame.
4. If the griddle has been raised, lower carefully into position
and replace the front panel of the range.

Griddle/Broiler

(Models G60-6R24RR, G60-6R24SS, G60-6R24RS,
G60-6R24CC, G60-6R24CR & G60-6R24CS)
See griddle seasoning before use.
Before turning on main gas supply, be sure all burner valves
are in the "OFF" position.

PRODUCT APPLICATION INFORMATION

General

The range is the workhorse of the kitchen because of its
versatility. Most frequently used in small applications, such as
cafes, schools, church kitchens, rehouses, and small nursing
homes where demands are less taxing. As a general rule of
thumb, one four to six burner range with a hot top will be
adequate for a restaurant seating 30 to 35.
The top of the range is designed for exibility and the
preparation of numerous di erent types of products. It may
be equipped with two, or even three di erent types of tops
and burners, depending on the menu needs. An operation
that cooks to order, or uses the range primarily as back-up
will nd that open burners will suit most of their needs.
Preparation of soups, stocks, or sauces is done on a hot top
where slow, even cooking is desirable.
Heating larger quantities of food can be done more
e ciently than heating small quantities. Pots and pans
should be covered whenever possible to reduce energy
consumption.
Page 12
1. Eight (8) ceramic bricks are supplied with each range.
These ceramics are to be placed in the burner section of
the griddle / broiler before it is put into operation.
2. Each burner has a ange on each side which will serve
as a rest for a pair of ceramics. Position two ceramics
between each pair of burners with the projections facing
downward. Place two ceramics between the outside
burner on each side, using the side lining ledges as the
outer support.
3. Light the pilots located in the broiler section.
4. Turn the burner valves completely on. Burners should
exhibit a 5/16-inch stable blue ame.
NOTE: If burners need adjustment contact an authorized
licensed gas technician.

Range Shut down

1. Turn all valves to the "OFF" position.
2. If the unit is to be shut down for an extended period of
time, close the in-line gas valve.
High acid sauces, such as tomato should be cooked in
stainless steel rather than aluminum to avoid chemical
reaction. Light colored sauces such as Alfredo may be
discolored by the use of aluminum, especially if stirred with
a metal spoon or whip. Saltwater shell sh may pit aluminum
pots if they are frequently used for this purpose.
NOTE: Many parts of the commercial range are raw steel. Hot
tops, griddles, springs, door hooks etc., can react with the
moisture forming rust. This occurrence is normal and not
considered a defect. Clean with a stainless steel or ber pad.
A light coating of cooking oil may be applied.

Open Burners

The most traditional uses of open burners are sautéing, pan
frying, and small stock pot work. Short-term cooking is the
most e cient use for the open burner. Pans should cover
as much of the grate as possible to minimize heat loss. The
maximum stock pot size to be used on an open burner is 12
inches, (305mm), diameter. Open burners should be turned
o when not in use to conserve energy. Leaving a ame
burning is of no advantage since the heat is instantaneous.
Part # 4523104 Rev 3 (03/04/10)