Cleaning - BREMA CB 246 Instrucciones Y Advertencias

‼
IMPORTANT:
• we recommend that the operations described in this manual should be performed by qualified,
authorized personnel.
• do not use corrosive substances to remove limestone from the appliance, because this will invalidate
the guarantee, and may cause serious damage to the materials and components of the appliance
• gloves suitable to protect against cuts must be worn when performing all operations involving handling
of sheet metal parts in particular
• gloves suitable to protect the skin against the substances used must be worn when performing all
cleaning and sanitizing operations
• wear suitable goggles during cleaning and sanitizing operations to protect the eyes against splashes
of the substances used
• take care not to spill water or solutions on the electric wiring of the appliance or the power supply
cable
9.3.a CLEANING
1. wait for ice cubes to drop, switch off appliance, disconnect from the electricity mains supply
and open door
2. remove all ice from container
3. remove flag support assembly (15 in Fig. 10) and ice-cube slide (16 in Fig 10) and extract
overflow pipe (17 in Fig 10) to drain water present in basin
4. refit the overflow pipe and fill the basin with a 25% solution of water and white vinegar, referring
to the table in Fig. 11
5. reposition ice-cube slide and flag support assembly
6. close door and operate appliance for five one-minute periods, with a five-minute interval
between each
‼
IMPORTANT: The pump must be in operation during cleaning cycles (check that water is
sprayed). If it is not, immediately adjust the timer regulation screw by turning it clockwise
until the indicator on the pin exits from the zone marked DEFROST.
To reach timer, loosen screws in front panel with a Phillips screwdriver, remove front panel by
pulling it upwards, and regulate timer with a flat-head screwdriver (Fig. 12).
7. switch off machine and disconnect it from electricity mains and water supply
8. remove top of appliance by lifting rear part and releasing it from front hooks (Fig. 13)
9. remove evaporator cover panel (Fig. 14) and clean top part of evaporator, bin, evaporator cover
panel and door with water and vinegar solution
10. remove any sediment from evaporator and evaporator cover panel using a brush with soft
bristles and a non-abrasive sponge
11. pour plenty of cold water onto the evaporator and with the aid of the brush, direct the sediment
removed into the basin beneath, taking care not to obstruct the holes in the base of the
evaporator. During cleaning of evaporator, take care:
• not to bend coils
• not to detach water supply pipes
• not to remove evaporator thermostat
12. remove (Fig. 10) and clean with ordinary washing-up liquid:
• flag support assembly (15)
• ice-cube slide (16)
• overflow pipe (17)
• sprayer bank (18), taking care to remove side caps (19)
• sprayer bank feed pipe (20)
• pump filter (21)
13. clean with the same washing-up liquid:
• evaporator cover panel
• inner basin
• bin
• door
14. thoroughly rinse previously cleaned parts with cold water
E
E
n
n
g
g
l
l
i
i
s
s
h
h