Helpful Hints; Troubleshooting - Black and Decker BD200MT Manual De Instrucciones

• Always ensure the workpiece is firmly held or clamped to prevent movement. Any
movement of the material may affect the quality of the cutting or sanding finish.
• Do not start sanding without having the sandpaper attached to sanding platen.
• Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces and
fine grit for the finishing surfaces. If necessary, first make a test run on scrap material.
• Do not allow the sandpaper to wear away, it will damage the sanding pad.
• Excessive force will reduce the working efficiency and cause motor overload.
Replacing the accessory regularly will maintain optimum working efficiency.
• If the tool overheats, especially when used at low speed, set the speed to maximum
and run it with no load for 2-3 minutes to cool the motor. Avoid prolonged usage at very
low speeds. Always keep the blade sharp.
Problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
Recommended accessories for use with your tool are listed on page 10 and 11 and are
available from your local dealer or authorized service center. In addition to Black &
Decker accessories, your BD200MT Tool Free Release system will also accept Porter
®
Cable and Stanley FatMax
®
regarding accessories, please call: 1-800-544-6986.
The use of any accessory not recommended for use with this tool could
WARNING:
be hazardous.

HELPFUL HINTS

TROUBLESHOOTING

Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
ACCESSORIES
oscillating tool accessories. If you need assistance
®
9
Possible Solution
• Plug tool into a working
outlet.
• Replace circuit fuse. (If
the product repeatedly
causes the circuit fuse to
blow, discontinue use
immediately and have
it serviced at a Black &
Decker service center or
authorized servicer.)
• Reset circuit breaker.
(If the product
repeatedly causes the
circuit breaker to trip,
discontinue use
immediately and have
it serviced at a Black &
Decker service center or
authorized servicer.)
• Have cord or switch
replaced at a Black &
Decker service center or
authorized servicer.)