Kalorik USK CM 25282 Manual De Instrucciones página 6

Fax +32 2 359 95 50
Wait until the brewing process is finished and the filter is empty
•
before removing the jug.
Practical hints: When the water tank is empty, wait a few more
•
minutes, as some water might still drip out of the filter before
removing the jug.
Note: a 2-hour auto-shut off feature is activated when operating
•
the coffee maker manually
PROGRAMMING THE COFFEE MAKER
To program your coffee maker to brew fresh coffee at a preset
•
time, first follow steps 1 to 4 in the "PREPARATION OF COFFEE"
section.
Make sure the coffee maker's clock is set to the right time.
•
Press the PROGRAM button twice. The clock will now display 12:00
•
with the word "TIMER" in the upper left corner. Use the HOUR and
MINUTE buttons to set the desired brew time.
Press the START/STOP button twice to activate the preset brew
•
cycle. The green AUTO light will illuminate when the brew time is
properly set.
When your preset brew time is reached and the coffee maker
•
starts its brew cycle, the green AUTO light will go out and the red
ON light will illuminate.
As with the regular brew cycle, an automatic two hour keep
•
warm cycle will commence after your coffee maker has finished
brewing. At the end of the two hours, the coffee maker will
automatically shut itself off.
NOTE: the 2-hour auto-shut off feature will also be activated when
operating the coffee maker manually
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
6
Assembly page 6/20
special instruction from Team
Print only
USK CM 25282 - 110127