Masterbuilt MES 130B Manual De Usuario página 22

HOW TO USE CONTROL PANEL & REMOTE CONTROL
To replace batteries:
• Slide belt clip to the left to remove.
• Press tab down on battery cover and pull out.
• Install 2 "AAA" Alkaline batteries. Check positive (+) and negative (-) symbols, on the case and bat-
tery, to insure proper installation.
• Replace the battery cover.
• Remove batteries before storing remote control.
GENERAL DRAWING NOTES:
1. BREAK SHARP EDGES .003-.010 INCHES (.08-.25 MM)
2. DIMENSIONS SHOWN ARE IN INCHES [MM]
3. MATERIAL: --
To test frequency range:
4. WEIGHT: --
• Turn unit on.
• Use remote to turn light on and off as you move away from unit.
• Remote control is out of frequency range when light will no longer turn on and off.
IMPORTANT
• Do not leave remote control exposed to sunlight for prolonged periods of time.
• Remote control has frequency range of up to 100ft (30m).
• Test frequency range before and during use.
TROUBLESHOOTING
If the remote is not working properly or not interfacing correctly with the controller, it may be due to
weak batteries, batteries being incorrectly installed or the remote is not correctly linked to controller.
Possible solutions
• Replace batteries and install according to image in battery housing.
• Link remote and controller by:
a. Turn Controller & Remote "ON",
b. Press and HOLD "SET TEMP" on controller for 3 seconds.
c. On the Remote press "MEAT PROBE", "LIGHT", "MEAT PROBE", "LIGHT" (all buttons must be
pressed within 5 seconds of each other). A short beep will occur after each button press.
• Keep batteries away from small children. If battery is swallowed consult a physician immediately.
• Be sure to insert batteries correctly. Improper installation may result in leaks and/or possible explosion.
• Do not dispose of batteries in fire.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh,etc) batteries.
22
*Batteries not
included
THE INFORMATION
CONTAINED IN THIS
DRAWING IS THE SOLE
PROPERTY OF
MASTERBUILT
MANUFACTURING.
ANY
REPRODUCTION IN
PART OR AS A WHOLE
WITHOUT THE WRITTEN
PERMISSION OF
MASTERBUILT
MANUFACTURING IS
PROHIBITED.
CAUTION
DO NOT SCALE DRAWING
General Tolerance
STANDARD METRIC
X.
N/A 1
X.X
0.030 0.80
X.XX
0.015 0.40
X.XXX
0.005 0.10 TITLE: --
X/X 1/32 N/A
Degree 1° 1°
Unless Otherwise Specified
SCALE: 1:1 Adam Carter
DRW.BY:
SHEET 1 OF 1 Default
REV: --
General Tolerance
Masterbuilt Manufacturing, Inc.
THE INFORMATION
CONTAINED IN THIS
1 Masterbuilt Ct STANDARD METRIC
DRAWING IS THE SOLE
X.
N/A 1
Columbus, GA 31907 PROPERTY OF
X.X
0.030 0.80
MASTERBUILT
X.XX
Phone: 706-327-5622 Fax: 706-256-5485
MANUFACTURING. 0.015 0.40
ANY X.XXX
0.005 0.10
REPRODUCTION IN
X/X
1/32 N/A
PART OR AS A WHOLE
Degree 1° 1°
WITHOUT THE WRITTEN
Unless Otherwise Specified
PERMISSION OF
MASTERBUILT
4/28/2010
DATE:
MANUFACTURING IS
PROHIBITED.
DWG Name