Transport And Handling - Victoria Arduino Venus Bar 2 Manual Tecnico. Instalacion, Uso, Mantenimiento

TRANSPORT AND HANDLING

MACHINE IDENTIFICATION
When contacting the manufacturer, Victoria
Arduino for any reason, always quote the
machine serial number.
The machine is transported on pallets contain-
ing several machines inside boxes secured to
the pallet by straps.
Before performing any transport or handling
operation, the operator must:
• wear safety gloves and footwear and overalls
with elasticised ends.
Pallets must be transported using an adequate
lifting mechanism (fork-lift truck type).
20
:
CAUTION COLLISION OR CRUSHING HAZARD
During the entire handling operation, the oper-
ator must make sure no one or nothing is inside
the operating area.
Slowly lift the pallet to about 30 cm from the
ground and move to the loading area. After
making sure there are no obstacles, persons or
things, proceed with loading.
Once at destination, always using an adequate
lifting mechanism (eg. fork-lift), after making
sure there is no one or nothing within the
unloading area, lower the pallet to about 30 cm
from the ground and transport it to the storage
area.
:
CAUTION COLLISION OR CRUSHING HAZARD
Before performing the following operation,
make sure the load is in place and is not likely
to fall when the straps are cut.
The operator, wearing safety gloves and
footwear, must now cut the straps and store
the product. To perform this operation, check
the technical characteristics of the product to
determine the weight of the machine to be
stored and take consequent precautions.
:
CAUTION POLLUTION HAZARD
Once the machine has been freed of the pallet
or container, do not discard these in the envi-
ronment - pollution hazard.