Sanus ALF113 Manual De Instrucciones página 13

3. Drill pilot holes using a 5.5 mm (7/32 in.) diameter drill bit. Remove wall plate template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 63.5 mm (2½ in.).
4. Install wall plate using lag bolts
16
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
3
. Tighten the lag bolts
17 17
63.5 mm
(2½ in.)
5.5 mm
(7/32 in.)
15
.
15
only until the washers are pulled firmly against the wall plate
18
4
16
16
18
17
.
13