Connect Gas Supply - Thermador SGS Serie Instrucciones De Instalación

Connect Gas Supply

NOTE: For solid surface material installations: Insert a wooden block between the
end of the screw and the bottom of the countertop. Do not overtighten adjusting
screw. Trim excess aluminum tape around cooktop flange.
The gas inlet to the unit is located at the right rear of rough-in box. After installing
a gas shut-off valve in an easily accessible location under the unit, install the pres-
sure regulator (supplied) to manifold pipe using Teflon tape on threads of manifold
pipe. To prevent possible damage to the gas pressure regulator, install it after the
rough-in box is in its permanent position.
Opening for Gas
Connection and
Electrical Cord
CAUTION:
Do not attempt any adjustment of the pressure regulator,
except conversion to propane.
Connect the gas supply line to the unit pressure regulator using a 1/2" flex gas line
connector between wall shut-off valve and pressure regulator.
Pressure
Regulator
Shows
Direction of
Gas Flow
Secure regulator to cooktop gas inlet using approved Teflon tape. Turn to hand
tighten plus 1/4 turn, not exceeding 1 turn for alignment.
Check supply line connections for leaks using a soap solution. Do not use a flame
of any sort.
1) Turn on gas.
2. Apply a non-corrosive leak detection fluid to all joints and fittings in the gas
connection between the shut-off valve and the range. Include gas fittings and
joints in the range if connections may have been disturbed during installation.
Bubbles appearing around fittings and connections indicate a leak.
3. If a leak appears, turn off supply line gas shut-off valve and tighten connec-
tions.
C of Cutout
L
for 30" models - 12-15/16" (312.8 mm)
for 36" models - 15-15/16" (389 mm)
for 45" models - 20-3/8" (30 mm)
Figure 5: Rough-in Box Area
Rough-in Box
1/2"
Female Pipe
Threads
Supply Cord
120 V
C of Wall
L
Receptacle
Flex Gas Line
Gas Shut-Off Valve
Cabinet Floor
Gas Stubout
Figure 6: Gas and Electrical Location
English 7