Adjusting The Power Of The Gas Spring; Moving The Control Ball - Auping 333B Instrucciones De Uso

4. Use
4.2 Adjusting the power of the
The power with which the back
section of the mesh base is raised
and lowered is adjustable. There are
three settings:
1. light (top hole): if you select the
2. normal (middle hole): standard
3. heavy (bottom hole): if you select
Adjusting the spring tension
1. Lift the back section half way up.
2. Unscrew the plastic notched nut
3. Attention: support the back
4. Place the eyelet of the gas
GB 6
All manuals and user guides at all-guides.com
gas spring
'light' setting, the back section is
easiest to push flat.
setting.
'heavy', the back section comes
up with extra force.
(see fig. 4).
section and remove the
connecting pin (take care with
the plastic bearing bush in the
eyelet of the gas spring).
spring in the required position.
The top hole towards the mesh
gives the smallest adjustment.
5. Press the connecting pin through
the lifting arm and the eyelet of
the gas spring (take care with
the plastic bearing bush in the
eyelet of the gas spring).
6. Tighten the plastic notched nut
(see fig. 5).

4.3 Moving the control ball

The control ball for your mesh base
is on the right, but it can easily be
moved to the left.
fig. 4
1. Untie the knot A from the cord B
and remove the ball C (see
fig. 6).
fig. 5
B
A
C
fig. 6