AEG SANTO C 8 18 42-6i Manual De Instrucciones página 15

All manuals and user guides at all-guides.com
Problem
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The Pilot light flashes.
The buzzer sounds. The
Alarm light flashing.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMAT-
IC or COOLMATIC button,
or after changing the
temperature.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
The appliance is not working
properly.
The temperature in the freezer is
too high.
The temperature is not set cor-
rectly.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
What to do if...
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Contact a qualified electrician.
Refer to "High Temperature
Alarm".
Set a higher temperature.
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
The compressor starts after a pe-
riod of time.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
15