Cequent Performance Products 75227 Instrucciones De Instalación página 4

1. Lower Exhaust – Detach 3 rubber isolators from exhaust; 1 on the driver side, 2 on the
passenger side. Use a spray lubricant to assist in detaching. Lower exhaust slowly and help
support it to prevent damage.
3. Adding Block and Bolt to Access Hole –Using the reverse fishwire technique, fish the 1/2"
Carriage Bolt (Item 7) and Block (Item 6) through the rearward access hole on the driver side
frame rail. For ease of hitch installation, leave the fishwire temporarily attached to lead bolt
through hitch slot.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
2. Temporarily Remove Rear Heat Shield – Using a permanent marker, trace on the heat shield
where it touches the inside fascia near both exhaust pipes. Remove Rear Heat Shield by removing
4 – 10mm hex bolts and 8 screws. Set Heat Shield aside, trimming will be required later.
4. Trim Fascia and Heat Shield – Using a utility knife and tin snips, trim the fascia and heat shield
respectively; approximately 3 7/8" wide by 1" high from bottom of fascia. Using the permanent
marker lines as a guide, trim the corners of Rear Heat Shield. Reinstall the Heat Shield.
Sheet 4 of 15 75227NP 08-28-15 Rev. A