SATA 05801 Manual Del Uso página 20

Taladro de litio sin escobillas de 12v; taladro de impacto sin escobillas
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 73
6) Setting of torque (see Figure E)
- Turn the torque adjusting ring to adjust the machine torque. When number 1 on the torque adjusting ring is aligned with the indicating arrow
above the machine, the torque is the minimum; when the mark on the torque adjusting ring is aligned with the indicating arrow above the
machine, the torque is the maximum.
The reference for setting is as follows:
1-3
4-7
8-10
11-13
14-15
7) Working lamp
- Machine with lighting working lamp:
Press the switch of the machine in use, and then the lamp is on; release the switch of the machine in use, and then the lamp is off.
8) Spindle self-locking (see Figure F)
- The function of spindle self-locking enables the machine to operate as a manual tool.
When the battery pack is out of power, you can manually rotate the machine to tighten or loosen the screws. At this time, the collet is fixed.
9) Battery power indicator
- Press the machine switch, and then the power indicator will be on for 5 s. You can judge the remaining power of the battery pack according to
the following table.
LED indicator display
10) Drilling
- When drilling on the surface of hard materials, use a pin punch and a hammer to mark the position to be drilled, to prevent the bit from slipping.
Hold the electric hand drill tightly, align the bit tip with the mark, and press the switch for drilling.
- Drill in with proper pressure. Do not over press or use offset pressure to enlarge the bore diameter.
Warning
Please use good high-speed steel bit when drilling on metal materials. Please use magnetic connecting rod (excluded)
when using short and small screw bit. Apply a little soap or other lubricants on thread when screwing so that it is
easily screwed in.
20
05801/05802
Screw the small screws
Screw the screws into soft materials
Screw the screws into soft and hard materials
Screw the screws into the hard materials
Screw in larger screws
High strength drilling
Remaining power
0-30%
30-60%
60-100%
中文
EN
DE
RU
KO
PT
JA
ES

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

05802

Tabla de contenido