SATA AE5302 Manual Del Uso página 57

4.2.7 Press the Up button to lift the main lift to about 30cm（i.e., below the height where the safety device is to be locked, rather than
the highest position; at this time, the two oil-filling ball valves shall be at the Close position）.
During oil filling of Sub Lift 30-35cm
Do not lift the main lift to the highest position
4.2.8 Turn the Work/Adjust switch to the Adjust position and set the red handle of the Sub Lift high-pressure valve to the Open position.
Work Adjust
4.2.9 Lift the sub-lift （to a height not greater than the main lift）, and then lower it. It is recommended to repeat this step 3 times.
Main lift
The height of the sub-lift shall not be greater than that of the main lift
4.2.10 Taking the main lift as the benchmark, lift the sub-lift to place the main lift and sub-lift at the same level, and turn the red
handle to close the high-pressure valve. When the main lift and sub-lift are adjusted properly, set the Work/Adjust switch to
Work, and set the time relay to 1.5~2s.
Main lift Sub-lift
AE5302/AE5302-3
Open Red handle
Sub-lift
Close
中文
The height shall not be
greater than that of the
main lift
Red handle After oil filling
of Main Lift
and Sub Lift
EN DE RU KO PT
Work Adjust
JA ES
57