Cleaning And Maintenance - cecotec RUNNERFIT STEP Manual De Instrucciones

ENGLISH
• PROGRAM KEY: When the treadmill is stopped, use this key to select one of the preset
programmes, (manual, P1-P12).
• MODE: When the treadmill is stopped, press this button to confirm changes and change
information (speed, time, distance, calories).
• START: Activates the treadmill.
• STOP: Slows the treadmill down until it stops.
• SPEED (3, 5, 7, 10): While the treadmill is operating, use these keys to restore speed.
• SAFETY CLAMP: The appliance does not work without these element. If during the workout
the clamp is moved from its position, the machine will stop.
• MP3: Your Runnerfit Step treadmill has 2 speakers which can be connected with any
electronic appliance (smartphone, mp3) allowing you to listen to your music through its
speakers on the panel while it is operating.
7. OPERATION
STARING UP THE TREADMILL
1. Press the "START" button. The product will start moving at the lowest speed (1 km/h), the
preset program time is 60 minutes.
CHANGING SPEED
a. Adjust speed with the speed adjustment keys on the control panel.
b. Adjust speed to 3, 5 or 7 with the speed-adjustment button on the panel.
ADJUSTING DISTANCE FROM THE MANUAL MODE
1. Press the MODE key once.
2. Select the desired program time (total minutes) with the speed adjustment keys.
3. Press the "START" button.
4. The display will count down from the selected time and will stop when it gets to 0.
ADJUSTING DISTANCE FROM THE MANUAL MODE
1. Press the MODE key twice.
2. Select the distance for the desired program (total distance in km) with the speed adjustment
keys.
3. Press the "START" button.
4. The treadmill's display will show the countdown from the selected time and will stop when
it gets to 0.
USING THE 12 PROGRAMMES (P1-P12)
1. Press the PROGRAM key until you select the desired program.
2. The default preset time of 30 minutes will blink on the display. Use the speed adjustment
keys to change this to your desired program time (5-60 minutes).
22 RUNNERFIT STEP RED SERIES
3. Press the START key to begin the program after a 30-second countdown.

8. CLEANING AND MAINTENANCE

• Inspect the appliance regularly to detect any damage or wear that may have occurred.
• Pay special attention to the parts that are most likely to wear off.
• Replace any defective parts immediately and avoid using the product until it is in perfect
conditions once again.
• We recommend that you occasionally lubricate the moving parts to avoid premature wear
off.
• Bear in mind that sweat is corrosive. Do not let it come into contact with the unit.
• To clean the product, use a sponge dampened with water. Do not use corrosive or solvent
products.
• Use a dry cloth to clean the plug and the control panel.
• Make sure the power switch is turned off and that the product is disconnected from the
power supply before carrying out daily maintenance.
• Do not use the appliance in wet or dusty places that could cause malfunctions.
• Install the treadmill in flat surfaces to avoid the appliance from falling and causing faults.
• Do not use the appliance for more than 1 hour. Take a rest after each hour.
• All parts and components must stay clean, both sides of the treadmill must be cleaned by
removing all rests of dirt. Make sure your shoes are clean before using the product. Use
soap and a dampened cloth to clean the treadmill, do not use solvents. Clean arm's sweat
and the treadmill after each use.
• The treadmill has been oiled by the manufacturer with antistatic oil. The machine can be
ENGLISH
RUNNERFIT STEP RED SERIES 23