Publicidad
ELECTRIC TURBO OVEN FTE 450S
CONTROLS
1) LEVELING
The oven is equipped with casters so that it is easier to move it around, and a screw to
adjust height.
ATENTION !
* Do not use any pressure adjustment valve that has not been specified by the manufacturer.
you might have problems with burners, such as maladjusted flames, clogged
* Do not try to adjust pressure adjustment valve on your own. Should any adjustment be necessary, contact
manufacturer or an Authorized Service.
* Any adulteration on the gas adjustment valve can compromise the whole functioning of the system, and it
characterizes unsafe action, with a risk of causing an accident.
* Any accident caused by misuse, improper use or adulteration of any original features of the equipment is
the user's responsibility and the manufacturing company is considered exempt from any liabilities on
damages that may have resulted from that. Therefore the
importance of reading the information contained in this manual.
3) STEAM CIRCUIT
The electronic controller is equipped with a "timer" that controls how long the solenoid valve should stay
open when controlled manually. Time is programmed by the user. (Check electronic controller configurations
steam time).
When time controlled by the "timer" is over, LED turns off automatically, indicating that
the solenoid valve is shut, and no more water is allowed to come in. Press steam switch key again to repeat
steam cycle. If water pressure is too high, more water than necessary will come in.
20
CARACTERISTICAS TECNICAS
Otherwise,
burners, etc.
RED HIDRÁULICA
Entrada de agua: es necesario un punto fijo de entrada de agua, de preferencia exclusivo, que obedezca
las especificaciones técnicas de presión. Adapte registro o canilla tipo jardín con rosca de 3/4"BSP.
REDE ELÉCTRICA
Instrucciones para enlace fijo:
La fuente de alimentación debe estar conectado a una caja eléctrica, que tiene un solo interruptor de
circuito como se describe a continuación. Alquiler de electricista con licencia de su confianza para hacer
el cableado.
Disyuntor
1 5 0 A
FTE 450S HORNO ELÉCTRICO TURBO
MODEL
MOTOR
PRESSION DE TRABAJO
CONSUMO ELECTRICO
TIEMPO DE CALIENTAMENTO
QTD. DE PAN DE 50g
DIMENSIONES DE LAS ASSADERAS
QTD. DE ASSADERAS
PRODUCCION HORA
TIEMPO DE COZIMIENTO
PESO NETO
PESO BRUTO
DIMENSIONES (A x L x C)
Disyuntores conforme
Sección del conductor
norma NBR NM 60898.
(calibre del cable)
3 5 m m ²
Conductores conforme
norma NBR 5410.
FTE 450S
2x1,0 Cv (Motor 220V)
13,2 KPA
11,7 Kw/h
20 min
450
58 x 70mm
15
1125 a 1350 pães de 50g
15 a 18 min
2,06 x 1,13 x 1,41m
09
Publicidad
