Warning; Box Content; Features - TechGrow Ballast Connect Micro Manual

_________________________________________________________________________________________________________
Thank you for purchasing the Ballast Connect Micro. This digitally controlled relay controller can switch 2 x
600W. Each socket is individually controlled by hybrid relays; during the switching the hybrid relays will
switch with an interval of 5 seconds. The Ballast Connect Micro has a lot of features due to its digital control.

Warning!

Follow the instructions in this manual carefully before using the Ballast Connect Micro. NEVER plug a lamp
into the Ballast Connect Micro and NEVER remove a lamp's plug from the Ballast Connect Micro when the
relays (sockets) are on. You may only connect or disconnect the plug(s) of the lamp(s) when the relays
are switched off by the "maintenance mode", otherwise the relays may be damaged (see section 5.8).
The relays of the Ballast Connect Micro are not covered by warranty.

Box content

1. Ballast Connect Micro
2. Mounting kit
3. Spare fuse
4. Manual
(Temp Probe not included)

Features

Suitable for 2 x 600W
•
Silent switching
•
Lamps are switched individually
•
2 digital clocks (24-hour/asymmetric)
•
Adjustable temperature protection
•
In case of overheating one lamp is switched off
•
Adjustable switch-on delay up to 300 minutes
•
All settings are saved in the event of a power failure
•
Display of minimum/maximum temperature
•
Various Temp Probes are available separately (not included)
•
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
Ballast Connect Micro
Digital relay controller
12