Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
CABINET PREPARATION AND
CLEARANCES
To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located
above the surface units should be avoided. If cabinet
storage is to be provided, the risk can be reduced by
installing a range hood that projects horizontally a
minimum of 5 in. (127 mm) beyond the bottom of the
cabinets. See C, Page 2.
This unit is designed for installation in the counter top
with zero clearance to adjacent walls and projecting
surfaces constructed of combustible materials. A 30-
inch minimum clearance is required between the top
of the cooktop and the bottom of an unprotected
cabinet. A 24 inch minimum distance is necessary
when the bottom of the wood or metal cabinet is
protected by not less than 1/4 inch of a flame retardant
material covered with not less than No. 28 MSG sheet
steel, 0.015 inch (0.4 mm) thick stainless steel, 0.024
inch (0.6 mm) aluminum, or 0.020 inch (0.5 mm) thick
copper. Flame retardant materials bear the mark:
UNDERWRITERS LABORATORIES INC.
CLASSIFIED
MINERAL AND FIBER BOARDS
SURFACE BURNING CHARACTERISTICS
Followed by the flame spread and smoke ratings., these
designations are shown as "FHC (Flame Spread)/
(Smoke Developed)". Materials with "O" flame spread
ratings are flame retardant. Local codes may allow other
flame spread ratings.
The minimum horizontal clearance from the sides and
back edge of the cooktop to the adjacent vertical
combustible walls is 0 Inches.
Models: CEF304, CEF365, CET304, CET365, CEP304, CEP365, CEP456
COUNTERTOP CUTOUT
C
DIMENSIONS
The cutout dimensions depend upon whether the
installation is for replacement, new construction, or
installation in a solid surface countertop material, such
as Surell™, Corian
cutouts, use of heat reflective tape and rounded
corners. Drawings G and H provide some guidelines
only (see Page 4). Always consult the countertop
manufacturer for specific Installation Instructions.
INSTALLING THE COOKTOP
DISCONNECT POWER BEFORE INSTALLING.
BEFORE TURNING POWER "ON", BE SURE THAT
ALL CONTROLS ARE IN "OFF" POSITION
SECURE COOKTOP TO
COUNTERTOP
The cooktop should be secured to the countertop using
the hold-down brackets provided. Prior to inserting
cooktop into cutout, turn cooktop upside down and
attach brackets to the burner box using the washers
and screws.
Place cooktop into cutout. Insert clamping screw into
the bracket and secure cooktop to countertop.
Use a wood block to protect fragile countertop
materials.
PAGE 3
®
etc. These materials require larger
WARNING:
E
F
G
Publicidad
