Unpacking And Set-Up - Shop-Vac 600BH Serie Manual Del Usuario

your appliance. Use only three-wire outdoor extension cords, which have
three-prong grounding-type plugs and three-pole receptacles which accept
the extension cord's plug. When vacuuming liquids, be sure the extension
cord connection does not come in contact with the liquid.
noTe: STATIC SHOCKS ARE COMMON IN DRY AREAS OR WHEN THE
RELATIVE HUMIDITY OF THE AIR IS LOW. THIS IS ONLY TEMPORARY
AND DOES NOT AFFECT THE USE OF THE APPLIANCE. TO REDUCE

unpAcking AnD SeT-up

1. Remove all parts from carton.
2. Refer to Dry Pick Up or Wet Pick Up Operation in this manual to ensure you have the proper filters installed for your cleaning operation.
3. A bucket (not included) is needed to use this vacuum. Refer to the chart in this section to make sure you have the proper bucket.
4. Slide securement arms on vacuum housing in an
1
outward motion. Place vacuum housing onto top of
bucket lining up the sides of the housing with the
sides of the bucket (figure 1).
6. Pull bucket handle in an upward motion and secure
2
handle in notch on each securement arm (figure
2).
8. Plug the cord into the wall outlet. Your cleaner is ready for use. i = on, o = off
noTe: MANY MORE USEFUL TOOLS ARE AVAILABLE AT YOUR LOCAL DEALER OR SHOP-VAC
Manufacturer
UPC
Material
Capacity
Height
Diameter
Handle Material
Handle Diameter
Where to Purchase
Image
United Solutions ® is a registered trademark of United Comb & Novelty Corporation.
Lowe's ® and the gable are registered trademarks of LF, LCC. All rights reserved; all are used with permission.
®
Questions? Visit Shop-Vac at www.shopvac.com or call 1-888-822-4644
United Solutions Encore Plastics Corp.
®
0 51596 10055 1 0 98262 01592 4
Plastic Plastic
5 U.S. Gal. (18.2 L) 5 U.S. Gal. (18.2 L)
14½" (36.83 cm) 14¼" (36.2 cm)
12" (30.48 cm) 12" (30.48 cm)
Metal Metal
/ (0.32 cm) /
"
1 1
8
Lowe's Lowe's
®
THE FREqUENCY OF STATIC
SHOCKS IN YOUR HOME, THE BEST
REMEDY IS TO ADD MOISTURE
TO THE AIR WITH A CONSOLE OR
INSTALLED HUMIDIFIER.
5. Slide securement arms in an inward motion and apply pressure with thumb
to each securement arm until it snaps tightly in place. Make sure all secure-
ment arms are clamped securely.
3
(0.32 cm)
"
8
®
Volts
120V
Ampere Rating
More Not More
Than Than
0 - 6
6 - 10
10 - 12
12 - 16
7. While facing front of housing, insert machine hose
end into intake port on left side of housing (figure
3).
®
WEBSITE.
Table A
Total length of cord in feet
150
25 50 100
AWG
18 16 16 14
18 16 14 12
16 16 14 12
14 12 Not recommended
3