General Set Up; Filter Installation And Cleaning; Dry Pick Up Operation - Shop-Vac SL Serie Manual Del Usuario

10. Press down on center of tool
holder until tab latches on bottom
of lid. FIGURE 10.
FIGURA 10

GENERAL SET UP

11. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
cleaning operation.
12. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
13. Insert machine hose end into inlet of tank. Twist
slightly to tighten the connection.
FIGURE 11
15. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 11.
16. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF
NOTE: Many more useful tools are available at your local
dealer or the Shop-Vac
Des questions?
Clients américains, composez le 888-822-4644 ou
consultez le www.shopvac.com 24 heures par jour.
Clients canadiens, composez le 905-335-9730
ou consultez le www.shopvac.ca 24 heures par jour.
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
NOTE: Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
PAGE 6
14. Attach the extension
wands to the accessory end
of the hose. Twist slightly
to tighten the connection.
FIGURE 11.
website.
®
without a filter will cause dust to discharge from blower
port and cause damage to motor.
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
NOTE: If foam sleeve (not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
17. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve (not standard with
all models) instead of the cartridge filter. When picking
up fine dust or powders a high efficiency filter bag (not
standard with all models) must be used with the
cartridge filter.
NOTE: If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
FIGURE 12
FIGURE 13
FIGURE 14
FIGURE 15
18. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 12.
19. Place filter retainer into the
top of the cartridge filter.
FIGURE 13.
20. Hold the tank cover with
one hand, turn the handle on
the filter retainer clockwise to
tighten, locking the filter into
place. FIGURE 14.
21. To remove the filter for
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise to
loosen and remove.
FIGURE 15.