Unpacking; General Set Up; Filter Installation And Cleaning; Dry Pick Up Operation - Shop-Vac EA Serie Manual Del Usuario

UNPACKING

NOTE: ACCESSORIES AND FILTERS MAY BE
PACKED IN TANK.
FIGURE 1
FIGURE 2
3. Remove any accessories and literature that may have
been packed in the vacuum tank.

GENERAL SET UP

4. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
cleaning operation.
FIGURE 3
6. Insert machine hose end with locking-nut into inlet of
tank. Turn locking nut to tighten. Do not over-tighten.
FIGURE 4
8. Attach one of the cleaning accessories (depending on
your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 4.
9. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF
NOTE: Many more useful tools are available at your
local dealer or the Shop-Vac ® website.
1. Pull lid latches out from
bottom, lift up on bottom of
latch and bring down to side
of tank. FIGURE 1.
2. Lift cover off of tank by
using the handle on top of
the cover. FIGURE 2.
5. Replace the tank cover.
Lift latches up and place in
the grooves on the cover as
shown in FIGURE 3. Push
in on bottom of latches to
lock in place.
7. Attach the extension
wands to the accessory end
of the hose. Twist slightly
to tighten the connection.
FIGURE 4.
Questions?
U.S. Customers call 888-822-4644
or visit www.shopvac.com 24 hours a day.
Canadian Customers call 905-335-9730
or visit www.shopvac.ca 24 hours a day.
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
NOTE: Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause dust to discharge from blower
port and cause damage to motor.
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
NOTE: If foam sleeve (not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
10. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve (not standard with
all models) instead of the cartridge filter. When picking
up fine dust or powders a high efficiency filter bag (not
standard with all models) must be used with the
cartridge filter.
NOTE: If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
FIGURE 5
11. With the tank cover in
an upside down position,
slide the cartridge filter
down over the lid cage,
pushing until the filter seals
against the cover.
FIGURE 5.
PAGE 5