Wall Mounting - PRASTEL 2PH150A Manual Del Usuario

IS2PH150A_01_07.doc
ENGLISH
2PH150A
7.1

Wall Mounting

- Pass the connecting cable through the hole in the fixing plate and then fix the plate to the wall with the screws
(fig. 7.1a).
- Make the connections to the terminal board (fig. 7.1.b)
- After checking the alignment and the correct working efficiency, re-mount the cover and fully tighten the
closing screw (fig. 7.1.c)
fig. 7.1c
fig. 7.1a
fig. 7.1b
7.2 Pole Mounting
The brackets supplied can be used for mounting on 4 – 4.5 cm diameter poles.
- Make an 8mm hole on the pole through which the connecting cable should pass (fig. 7.2a).
- Pass the connecting cable through the hole and through the opening in the fixing plate.
- Position the U brackets on the pole and fix them with the supplied screws (fig. 7.2b).
- Make the connections to the terminal board.
- After checking the alignment and the correct working efficiency, re-mount the cover and fully tighten the
closing screw.
fig. 7.2a
fig. 7.2b
8