Package Contents; Accessories (To Be Ordered Separately); Environmental Protection; Safety Instructions - Bosch CRR 120 Instrucciones De Funcionamiento

2.

Package contents

R
CRR 120
R
Accessory set (voltage stabilizer connection)
R
Operating instructions
2.1 Accessories
(to be ordered separately)
Description
Voltage stabilizer
Coupling set
Hose set
Instructions for using the voltage stabilizer:
Replace the enclosed power line with an IEC
plug, if necessary, with a power line with a
country-specific mains plug (100 – 230 V/
13 A). Never use AC adapters, such as travel
adapters!
¶
Do not overload the mains supply circuit
and the mains socket, if in doubt, contact
an electrician.
3.

Environmental protection

i
Please bring all packaging parts to the correspond-
ing collection points for recycling. Outside the Feder-
al Republic of Germany please observe the appropri-
ate specifications for each country in question.
Robert Bosch GmbH
4.
i
The following safety instructions must not be viewed
as being full and complete in scope, and they refer
solely to any work conducted directly on the compo-
nents.
!
Observe the legal accident prevention regulations!It
is assumed that all people working on the system are
Order Number
trained and instructed personnel only, and that all
work conducted is done so correctly and with due
1 687 022 873
0 986 613 491 diligence!
0 986 613 488
!
Make sure that all systems and devices are used as
intended only!
!
Maximum risk of injury from moving parts!
!
Detach or connect all electrical cables/cable plugs
when de-energized only. Avoid any spark formation!
!
The CRR 120 may be operated using a suitable volt-
age stabilizer at 24V DC only.The ground conductor
(PE) on the voltage stabilizer must be connected.
When connecting the CRR 120 make sure that the
polarity is correct, the device must never have its
polarity reversed!
!
The 24 V connection (-) must be connected to the
ground conductor(PE), see here to chapter 5.2
(Electrical connection).
!
Caution - risk of crushing: Alterations to the pneu-
matic part of the test set-up may only be conducted
when the CRR 120 has been de-energized, to do
so the CRR 120 has to be switched off at the main
switch. The compressed-air pipes may only be de-
tached or connected when the system is unpressur-
ized.Never use the CRR 120 with any worn or faulty
accessory parts.
!
Type of protection IP 20: The device may be oper-
ated in a specified test bay only.
Package contents | CRR 120 | 11

Safety instructions

0 986 629 504
en
|
2020-08-24