Technical Characteristics - Comunello Automation BORDER 400 Instrucciones De Uso Y De Instalacion

• For the power supply cables it is advisable to use flexible cables with harmonised type polychloroprene insulating sheath (FG16) with
a minimum conductor section of 1.5mm
• When drilling the outer case to insert the power and connection cables and when fitting the cable glands, take care to install all the parts
in a manner that maintains the IP protection characteristics of the box unchanged as far as possible. Ensure the cables are fixed in a
stable and secure manner.
• The rear of the box is equipped with knockouts for wall fixing (knockouts for fixing holes using anchor bolts or holes for fixing with
screws). Take all the measures required to ensure the installation procedures do not affect the IP rating.
• Any mounting of a push-button panel for manual control must be performed by positioning the push-button panel so that the user does
not find themselves in a dangerous position.
• The gearmotor used to move the barrier must be in compliance with the prescriptions of EN 12453, point 5.2.7.
• The Power Supply output D.S. must be used for photocells. Alternative uses of this output are not permitted.
• The control unit can perform the operation test of the photocells upon each operating cycle, guaranteeing protection against the failure
of Category 2 anti-crushing devices according to the provisions of section 5.1.1.6. of EN 12453. Therefore, if the safety devices are
not connected and/or are not working, the control unit is not enabled for operation.
• The device can be used by children no older than 8 years old and people with reduced physical, sensory or mental capabilities, or lack
of experience or without the required knowledge, but only under surveillance or after having received instructions about the safe use of
the device and the hazards inherent in it. Children must be supervised to make sure they do not play with the appliance. Cleaning and
maintenance intended to be carried out by qualified personnel.
For correct operation of the receiving radio part, in case of use of two or more control units, installation at a distance of at least 3 meters
from each other is recommended.
All operations that require the control unit box to be opened (connection of cables, programming, etc.) must be carried out by
CAUTION:
expert personnel at the time of installation and maintenance. For all further operations that require the box to be re-opened.
USER CAUTION
• The device must not be use by children or people with reduced psychophysics abilities, or at least in case they are supervised or
educated on the operation and its use.
• Do not allow children to play with the device and keep them out from the remotes.
• CAUTION! preserve this instruction manual and respect the important safety prescriptions that it contains. Failure to comply with the
prescriptions could cause damage and serious accidents.
Frequently examine the system to detect any signs of damage. Do not use the device if repairs are required.
11.2

TECHNICAL CHARACTERISTICS

• Back-up Battery input:
• Flashing light output:
• Motor outputs:
• Photocells power supply:
• Working temperature:
• Radio receiver:
• Transmitters:
• Max TX codes stored in memory:
• Board dimensions:
2 .
24 V 7A/h min.
24 V 4 W max.
24V 1 x 50 W max.
24 V 5 W max.
-10°C ÷ +55°C
433 MHz
18 Bit or Rolling Code
120
100x105 mm.
COMUNELLO ®Copyright 2020 - All rights reserved
29