Installing The Glass Shades And Bulbs - HAMPTON BAY Campbell 41350 Guía De Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly - Attaching the lights
1
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
NOTE: Notice the location of the fan's slide switch. This is
the switch used to change the fan's directional rotation.
For more information on the operation of this switch, see
Operating Your Fan and Remote Control on page 12.
NOTE: If you need an extra switch cup (or cover) for the
non-light option, please call 1-800-283-6513 (M-F 9:00am
to 4:30pm EST).
Remove the three screws (RR) on the switch cup cover of the
light kit fitter assembly (E).
Connect the wires from the light kit fitter assembly (E) to the
wires from the switch cup of the fan-motor assembly (D) by
connecting the molded adaptor plugs together (blue to black,
white to white). Carefully tuck all wires and splices into the
switch cup.
Align the three holes in the switch cup cover of the light kit
fitter assembly (E) with the three holes in the switch cup
of the fan-motor assembly (D). Make sure the notch in the
switch cup cover of the light kit fitter assembly (E) clears the
reversing switch in the switch cup of the fan-motor assembly
(D). Position the light kit fitter assembly (E) and re-install the
three screws (RR) that were removed in first step to secure
the light kit fitter assembly (E).
RR
2
D
E
12
Installing the glass shades
and bulbs
WARNING: Allow the glass shades to cool completely before
removing.
WARNING: Over lamping the light kit will result in the lights
shutting down until the proper wattage of bulbs are installed.
Reset the lights by turning off the lights, replacing the bulbs
with the correct wattage bulbs, and turn the lights back on.
CAUTION: Make sure the power is off before attaching or
removing the glass shades.
NOTE: Using a E12 CFL type bulb will eliminate the dimming
option, and may cause flickering.
Insert the glass shade (H) into the light kit fitter assembly
(E) glass holder by carefully squeezing the steel tensioners
(TT) on the light kit fitter assembly (E) socket together.
Gently slide the glass shade (H) over the steel tensioners
(TT). Make sure the glass shade (H) is fully inserted into
the socket for a secure fit. Repeat this procedure for the
remaining glass shades (H).
With the power off, install the light bulbs (I) into the light
bulb sockets.
TT
D
E
H
I

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

52-bvd

Tabla de contenido