Assembly; Installing The Receiver - HAMPTON BAY Campbell 41350 Guía De Uso Y Mantenimiento

Assembly - Hanging the Fan (continued)
3

Installing the receiver

WARNING: To reduce the risk of fire or electric shock,
remember to disconnect the power. The electrical wiring
must meet all local and national electrical code requirements.
The electrical source and fan must be 110/120 volt, 60Hz.
Do not use this product in conjunction with any variable wall
control. Incorrect wire connection can damage this receiver.
CAUTION: Do not install in a damp location or immerse in
water (for indoor use only). Do not pull on the leads, or cut the
leads shorter. Do not drop or bump the unit.
□
Position the supply wires to the left side of the slide-on
mounting bracket (A); position the fan wires to the right
side.
□
Partially insert the receiver (K) (flat side up) into the slide-
on mounting bracket (A) until one end rests on the ball/
downrod assembly (B).
B
K
A
4
Setting the code on the remote control
and receiver
NOTE: The frequencies on your receiver and remote
control have been preset at the factory. Before installing
the receiver, make sure the dip switches on the receiver
and remote control are set to the same frequency. The dip
switches on the remote control are located inside the battery
compartment.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place, as this will damage the
remote control. Dispose of used batteries properly and keep
batteries out of the reach of children.
□
Remove the remote control (J) battery cover by pressing
firmly on the arrow and sliding the cover off.
□
Slide the code switches to your choice of either up or down.
The factory setting is up.
□
Slide the code switches on the receiver (K) to the same posi-
tion as set on the remote control (J).
□
Replace the battery cover on the remote control (J).
J
9
Please contact 1-877-527-0313 for further assistance.
ON DIP
1 2 3 4
HAMPTONBAY.COM
K