JOCCA 9066 Manual De Instrucciones página 7

MAINTENANCE
CAUTION: DO NOT PERFORM MAINTENANCE ON THIS APPLIANCE WHEN HOT. ALWAYS
WAIT UNTIL THE APPLIANCE HAS COOLED TO A SAFE TEMPERATURE.
To enjoy years of outstanding performance from your heater make sure you perform the following
maintenance activities on a regular basis:
• Keep exterior surfaces clean.
• Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
• While washing the appliance, be sure to keep the area around the burner and pilot assembly dry at all
times. If the gas control is exposed to water in anyway, DO NOT use it. It must be replaced prior to use.
• Airflow must not be obstructed. Keep controls, burner, and circulation air passageways clean.Signs
of possible blockage include:
– Gas odor with extreme yellow tipping of the flame.
– Heater does NOT reach the desired temperature.
– Heater glow is excessively uneven.
– Heater makes popping noises.
• Spiders and insects can nest in the burner and orifices. This dangerous condition can damage the
heater and render it unsafefor use. Clean burner holes free of any spider webs, nests and debris by
using a heavy-duty pipe cleaner. Compressed air may also help in clearing away smaller particles.
NEVER use wood or plastic tooth picks to clear ports or other openings becausewood and plastic
can break and block the ports.
• Carbon deposits may create a fire hazard. If any carbon deposits develop, clean the dome and heating
element with warm soapy water. The dome and heating element MUST NOT be painted.
• The reflector may be cleaned with soapy water, but should NEVER be painted.
Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal.
Frequently check forcorroded areas and repair them promptly.
NOTE:
INSTALLATION & REPAIR SHOULD BE DONE BY A QUALIFIED SERVICE PERSON.
SAFETY
BEWARE OF SPIDERS
CAUTION: BURNER TUBES MUST BE INSPECTED AND CLEANED BEFORE FIRST USE.
Spiders and insects can nest in burner tubes or orifices during warehousing, transit or between periods
of use.This dangerous condition can damage the heater and create an unsafe operating condition for
the user. If spider or insect nests are detected, clean burner holes by using aheavy-duty pipe cleaner.
Compressed air may help clear away smaller particles.
-22-
Paso 1:
Coloque la placa base sobre una superficie plana. Alinee la base con la placa base y presiónela
hasta que quede ajustada.
Paso 2:
Introduzca el regulador y la manguera por el agujero. Alinee el control del calefactor con
la base. Empuje hacia abajo el conjunto de control del calefactor hasta que quede ajustado
en su sitio.
Paso 3: Fije la pantalla emisora al conjunto de control del calefactor con cuatro tornillos Phillips.
Pasos 4 y 5:
Comenzando con el panel con clavijas de bloqueo a cada lado, coloque ambas secciones
del reflector de calor sobre la pantalla del quemador. Fije cada sección con las clavijas.
(Sección uno: dos clavijas; sección dos: una clavija; sección tres: sin clavijas). Fije el reflector
de calor a la pantalla emisora utilizando los tornillos suministrados.
Paso 6:
Coloque la guarda de seguridad alrededor del conjunto de control del calefactor, alinéela
con las muescas y fíjela con los tornillos suministrados.
1
2
4
5
3
6
-7-
ES