Husqvarna T536 LiXP Manual De Instrucciones página 20

Checking wear on cutting equipment
Li-ion Li-ion
Check the chain daily for:
• Visible cracks in rivets and links.
• Whether the chain is stiff.
• Whether rivets and links are badly worn.
Replace the saw chain if it exhibits any of the points
above.
We recommend you compare the existing chain with a
new chain to decide how badly the existing chain is worn.
When the length of the cutting teeth has worn down to
only 5/32 inch (4 mm) the chain must be replaced.
Guide bar
Li-ion Li-ion
Check regularly:
• Whether there are burrs on the edges of the bar.
Remove these with a file if necessary.
• Whether the groove in the bar has become badly
worn. Replace the bar if necessary.
• Whether the tip of the bar is uneven or badly worn. If
a hollow forms on the underside of the bar tip this is
due to running with a slack chain.
20 – English
GENERAL SAFETY PRECAUTIONS
• To prolong the life of the bar you should turn it over
daily.
WARNING! Most chainsaw accidents
!
happen when the chain touches the
operator.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Do not tackle any job that you feel you
are not adequately trained for. See
instructions under the headings
Personal protective equipment, How to
avoid kickback, Cutting equipment and
General working instructions.
Avoid situations where there is a risk of
kickback. See instructions under the
heading Machine's safety equipment.
Use the recommended protective
equipment and check its condition. See
instructions under the headings
Technical data and General safety
precautions.
Check that all the chainsaw safety
features are working. See instructions
under the headings General working
instructions and General safety
precautions.
Never use a chainsaw by holding it with
one hand. A chainsaw is not safely
controlled with one hand. Always have a
secure, firm grip around the handles with
both hands.
SAVE THESE INSTRUCTIONS