Adjusting The Brakes; Repair And Maintenance - Razor sportMod 15130412 Manual Del Usuario

ASSEMBLY AND SET-UP
❑ Attaching the Front Wheel
1
Remove the packing material
from the front fork.
❑ Testing the Brakes
To use the brake, squeeze the lever to increase the pressure on the brake. The brake lever is fi tted with a cable adjuster
to compensate for cable stretch and/or to fi ne-tune the lever movement to brake engagement. If the brake is not
engaging properly, follow instructions for adjusting the brakes outlined below.

❑ Adjusting the Brakes

1
To adjust the brake play, thread
the brake lever adjuster in or out 1/4
to 1/2 turn until the desired brake
adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.

REPAIR AND MAINTENANCE

Check the Razor web site for any updates on the latest repair and maintenance procedures.
Turn power switch off before conducting any maintenance procedures.
❑ Infl ating the Tires
Tires are infl ated when shipped, but they invariably lose some pressure between the point of manufacturing and
your purchase.
1
Using a bicycle style tire pump
equipped for a Schrader-type valve,
infl ate the front tire to the PSI
indicated on the sidewall of the
tire.
2
Insert the wheel into the front
fork with the lock washers on the
outside of the fork.
2
If the brake lever adjuster is
threaded outward and the brake
still has too much slack, use the
rear brake adjuster for additional
adjustment.
3
Insert the tab on the lock
washer into the hole on the front
fork and tighten the nuts with the
supplied wrench.
4
WARNING: The brake
is capable of skidding the tire and
throwing an unsuspecting rider.
Practice in an open area free from
obstacles until you are familiar with
the brake function. Avoid skidding
to a stop as this can cause you to
lose control or damage the rear tire.
Note: The brake lever contains a
safety switch to stop the motor
when the brake is applied. In an
emergency, applying the brake
will always stop the motor. Do not
disable or replace this lever with
anything other than a genuine Razor
replacement part.
Note: The pressurized air supplies
found at gasoline stations are
designed to infl ate high-volume
automobile tires. If you decide to
use such an air supply to infl ate
your Sport Mod tires, fi rst make
sure the pressure gauge is working,
then use very short bursts to
infl ate to the correct PSI. If you
inadvertently over-infl ate the
tire, release the excess pressure
immediately.