DITEC OLLY M Manual Para La Instalacion Y La Manutencion página 13

5. STARTING
- Select the desired opening direction with DIP2.
- If required, activate the closure thrust by setting DIP1=ON.
- Set TC to the maximum.
- Turn on the power.
Warning: the control panel performs an automatic RESET on each
start (or change of DIP2) and the first opening or closing manoeuvre
is performed at low speed allowing the automatic self-learning of
the stop positions (acquisition). Check that the door is operating
correctly with subsequent opening and closing commands.
- If required, set the automatic closure with the TC.
- Connect possible accessories and check they are functio-
ning.
Warning: if the RER radar is used, set the radar dip-switch
RER=DX.
- If the automation encounters an obstacle during closure, it is
detected and the automation opens again. If the automation
encounters an obstacle during opening, it is detected and the
automation stops. If the obstacle is detected twice in a row,
it is considered as the new stop until it is removed.
- The automation is equipped with the Push&Go function.
By manually pushing the door the motorised manoeuvre is
started.
6. MAINTENANCE PROGRAM (each 6 months)
Without 230 V~ power:
- Clean the moving parts (the carriage guides).
- Check the belt tension.
- Clean sensors and photocells (if present).
- Check the stability of the automatic system and make sure
that all screws are correctly tightened.
- Check the alignment of the doors and the stop position.
Turn on the 230 V~ power:
- Check the stability of the door and that the movement is
regular and without resistance.
- Check that all command functions are operating cor-
rectly.
- Check that the photocells are operating correctly (if pre-
sent).
- Check that the door's developed powers are in accordance
with the present standards.
WARNING: for spare parts, see the spares price list.
13
GB
OLLY M - IP1894