Technical Details - DITEC OLLY M Manual Para La Instalacion Y La Manutencion

1.

TECHNICAL DETAILS

Power supply
Absorption
Accessories power supply
Thrust
Opening speed (max)
Closing speed (max)
Intermittence
Max. door weight
Temperature
Degree of protection
2. REFERENCE TO ILLUSTRATIONS
The given operating and performance features can only be guar-
anteed with the use of DITEC accessories and safety devices.
2.1 Standard installation references (fig. 1)
[1] Actuator
[2] Radar
[3] Push-button panel
[4] Connect the power supply to a wall socket
2.2 Automation references (fig. 2-6-9)
[5] Wheel unit
[6] OLLYM support container
[7] Casing
[8] RER radar cable plug
[9] Belt connection bracket
OLLY M
230 V~ / 50-60 Hz
0.2 A
24 V= / 0.3 A
30 N
0.4 m/s
0.2 m/s
S2 = 30 min
S3 = 50%
40 kg
-20° C / +55° C
IP20
3. INSTALLATION
Unless otherwise specified, all measurements are expressed
in millimetres (mm).
- OLLY M is prepared for righthand opening (fig. 2).
For lefthand opening (fig. 3): remove the casing [7]; remove
the actuator [1] from the support container [6]; disassem-
ble the wheel unit [5]; turn the actuator through 180° [1];
assemble the wheel unit [5];
- Dismantle the door wing and fix the belt connection brac-
ket [9] so that subsequent height adjustment of the belt is
possible (fig. 6-9).
- Secure the belt to the bracket [9] on the opening side of
the door wing.
- Fit the door wing and fix the OLLY M support container [6]
as shown in fig. 8 and 9.
- Based on the opening direction, introduce the belt into the
actuator as indicated in fig. 4 and 5.
Note: the stroke of the door must be limited by suitable stops.
- Introduce and fix the actuator [1] with the wheel unit [5] in
the previously fixed OLLY M support container [6] on the
opening side of the door wing.
- Fix the belt on the belt connecting bracket [9] on the closing
side of the door and tension it correctly.
Warning: in order to operate correctly, the belt should not be too
taught and must be levelled in regards to the wheel unit [5].
- Manually move the door and make sure that it moves
freely and that the belt moves without resistance. Make
any possible adjustments on the door, the belt connection
bracket [9] or the wall fixing screws.
Warning: check that there is at least 20 mm between the wheel
unit [5] and the belt connection bracket [9] with the door com-
pletely open or closed.
- Fix the casing [7] to the actuator by means of the supplied
velcro. The casing can be fitted in 2 ways as illustrated in
fig. 9.
11
GB
OLLY M - IP1894