Descargar Imprimir esta página

Intended Use Of The Machine; Technical Data - GreenWorks Tools Manual De Utilización

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 9
EN(
ORIGINAL INSTRUCTIONS)

Intended use of the machine

–– The Brush Cutter/String trimmer is only intended for cutter grass, weeds, Bushes, undergrowth it should not be used for any
other purpose such as Edging or hedge cutting as this may cause injury.

Technical Data

Rated power -----------------------------------------------1200W
Cutting line feed -------------------------------------Bump feed
No load speed ----------------------------------5300/6500 rpm
Cutting line diameter -------------------------------------2.0mm
Mounting and Operation
· Do not connect the machine to the mains socket before it is
completely assembled.
· The cutting line continues to rotate for a few seconds
after the trimmer is switched off. Allow the motor/cutting line
to stop rotating before switching "on" again.
· Do not rapidly switch off and on.
Action
Delivery Scope
Connecting the Shaft
Mounting the Auxiliary Handle
Attaching the Shoulder Strap
Connecting the Extension Lead
Troubleshooting
Problem
Trimmer fails to operate
Trimmer runs intermittently
Garden product labours
Garden product does not cut
Line can not be fed
Line keeps breaking
Disposal
Do not dispose of garden products into household waste! Only for EC countries: According to the Eu-
ropean directive 2002/96/EC for Waste Electrical and Electronic Equipment and its implementation into
national law, electrical and electronic equipment that are no longer usable must be collected separately
and disposed of in an environmentally correct manner.
Cutting diameter-------------------------------------------45cm
Cutting spool capacity------------------------------------5m
Weight according to EPTA-Procedure
01/2003------------------------------------------------------4.6Kg
Protection class-------------------------------------------
· Do not hand bump the line feed as it could be hot.
· Remove any grass from spool cover when changing
line or spool.
· It is recommended to use a approved line. Cutting
performance will vary with different line.
· Use the original spring when replacing spool.
Figure Action
1
Starting
2
Stopping
3
Working Advice
Feeding the Line
5
Replacing the Line Spool
6
Winding Line on Spool
Possible Cause
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Extension cable damaged
Internal wiring of garden product
damaged
Grass too high
Line too short/broken off
Spool empty
Line inside the spool entangled
Line inside the spool entangled
Trimmer used incorrectly
4
Figure
Corrective Action
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Inspect cable, replace if damaged
Contact Service Agent
Contact Service Agent
Cut in stages
Feed the line manually/automatically
Replace the spool
Inspect the spool, rewind if necessary
Inspect the spool, rewind if necessary
Only trim with the tip of the line,
avoid stones, walls and other hard
objects. Feed the line regularly to
maintain full cutting width.
/II
7
7
8
9
10
10
1)

Publicidad

loading