How To Use Accessories - Eureka AIRSPEED AS1090 Serie Guia Del Propietario

C A U T I O N
When using tools, always place handle
in upright position to raise vacuum to
highest carpet setting. Brush roll will
continue to turn when vacuum is turned
on and handle is in upright position. Do
not tilt vacuum forward while using tools.
To avoid damage, do not set vacuum on
carpet, carpeted stairs, furniture or
fringed rugs when using tools.
Before using accessories
• Turn air path selector knob to 'tools' (Fig. 1).
• Pull out cord to desired length.
Do not pull past red line (Fig. 2).
• Push cord into cord clip (Fig. 3).
• To store, press switch to retract cord (Fig. 4).
2-Position wand
WAND
1 1
(wand 2 on some models or available for purchase)
• Loosen wand and hose from vacuum.
• Push tool onto end of wand (Fig. 5).
• Short wand: Push hose release button to
remove wand 1. Attach tool to end of hose.
WAND
2 2
• Longer wand: Slide off wand 2 and turn over,
then push opposite end onto wand 1.
Dusting brush
Use for furniture, drapes and vents.
Crevice tool
Use for baseboards, corners
and tight spaces.
Turbo nozzle
(on some models or available for purchase)
Use for furniture and stairs.
Stairs – make sure vacuum is below
you, pushed against the bottom step.
• Attach turbo nozzle to end of hose.
NOTE: Hose length can be increased by
releasing the hose from the hose retainer
on back of unit. Reposition hose inside
hose retainer after using accessories.
Eureka Customer Service HELPLINE 1-800-282-2886

How to use accessories

Fig.1
Fig.3
Fig.5
Fig. 2
Fig.4
Wand 1
Wand 2
(on some models)
www.eureka.com 3 3