sanindusa PLAN Instrucciones De Montage Y Manutencion página 56

//INSTALLATION
3 – Before assembling the panel, consider using the provided adjusting
screw in order to optimize the operation of the mechanical button. If
needed, assemble the adjusting screw to the mechanical button at the
internal side of the panel and adjust it to the desired distance
Pay atention, steps 4-7 must be completed within 30 seconds
6
4 – Insert the battery into the battery box.
5 – Assemble the panel to the cover seat.
6 – This product includes a self adjusting sensor. The ideal sensor
range for the specific location will be set automatically. Right now,
check that no objects are in front of the sensor.
7
7 – Remove the protective sticker covering the sensor.
8 – Wait about 30 seconds before you step or put your hand within the
sensor range. As an indication that the self adjusting is taking place, a
red light in the sensor eye will flash continuously. The solenoid valve
will be opened and closed for 1 second as an indication that the ideal
sensor range was set and the product is ready for use.
9 – Tighten the panel to the cover seat with the bottom screw.
9
10 – To operate, step within the sensor range for a minimum of 8
seconds. Move away and the flush valve will flush a few seconds after
your departure.
11 – If needed adjust the flow rate by turning the regulating valve. In
order to avoid entering into the self adjusting mode, do not disconnect
the cables between the electronic unit and battery box.
12 – If the range is unsatisfactory, refer to the section entitled
"Settings Adjustment".
56//57