oneConcept 10033139 Manual De Instrucciones página 20

EN
20
4. Appointment "ON": In standby mode, press"
the appointment turn-on time in 00-12 hours. After complete setting, the
display shows the appointment turn-on time and also the light
display automatically decreases 1 hour for each hour passed. When the
appointment power-on time arrived, the product will automatically turns
on. The default setting temperature is 23 °C during appointment turn-on.
The side image is an example to set appointment turn-on time to 8 hours:
Note: If not setting the temperature and weekly program, the product will
automatically turn-off after 12 hours of continuous work, and enter into
standby.
Function operation (ONLY by remote control)
1. Press , the product enter into working status.
2. Press ", the product enter into working status. The product works with
low heating(1000W) and display shows „--/ ".
Press again, changes to high heating(2000W) and display shows „--/
3. Press button to set swing function, press again, will stopped.
4. Press button to set timer(00-12hours) and lighted
Set current TIME/DAY (can set both under standby mode & working status)
Press SET button for one time, the display shows "12" as default: Press +/- to
set current hour. Press SET again, the display shows minute " 30", press +/- to
set current minute. Then press SET for third time, the display shows the day
"d7". Press +/- to set current day (Monday-Sunday: d1-d7) . Then press OK to
confirm the setting, the display will show previous settings.
timer button, you can set
is on. The
.
".