oneConcept 10033139 Manual De Instrucciones página 22

EN
22
After complete setting of current TIME/DAY, below is the steps to set
weekly program
After complete setting of current TIME/DAY, below is the steps to set weekly
program:
1. Press , the product enter into working status.
2. Press P. The display shows „P, it enter into weekly program setting.
3. Press DAY: The display shows d1~d7, set to working day(Monday-
Sunday: d1~d7). Such as set Monday:
Note: In order to distinguish between setting current day & working day:
Current day - Monday-Sunday: d1~d7
4. Press EDIT, the display shows P1~P6(for each day, it can be set maximum
6 time periods).Such as setting P1:
5. Press TIME/on , the display shows "00" as default. Press TIME/on
continuously to set the turn-on time. Such as set the turn-on time
7:00am (Memo: the setting time 0-24 for choice)(:
6. Press "TIME/on" , the display shows the pervious step turn-on time by
default. Press "TIME/on" continuously to set the turn-off time. Such as
set the shutdown time at 13:00 pm (the display as figure ), (Note: turn-off
time later than turn-on time, when turn-on time same as turn-off time,
the unit in stand by mode):
7. Press +/- to set the target temperature (temperature range 10 – 49 °C).
8. Repeat steps 2-7 above. You can set the whole weekly program (and each
day. The work of each segment opens, the time of shutdown).
9. After above setting, press DAY choose the unit turn-on day of the week,
then press EDIT to choose the turn-on time of the day, then Press +/- to
set desired temperature (temperature range 10-49 °C). Press OK to
confirm the setting.
10. To cancel the weekly function, press the " P" again. The light "P" will go
off. The weekly program is off. The product will revert to the previous
function working status.
Note: After the above settings are completed and P program is working,
press DAY/ EDIT/ TIME/ON/ TIME/OFF to check the setting time of each day
and time periods.
• The turn-on time periods 00-24 hours. It cannot be set to minutes.
• The"TIME/OFF" cannot be less than"TIME/ON".
• When the"TIME/ON" is the same as"TIME/OFF", the time period enters
into standby mode.
Note: : If main switch off, power cut off, or plug out, it need reset. You can
press SET to check you set Time /Day.