Cleaning And Maintenance - oneConcept 10033139 Manual De Instrucciones

Set open-window detection(ONLY by remote control)
• Press , the product enter into working status. Heating for a moment
until stable.
• Press on the remote control. „
displayed "23" by default.
• Press +/- to set target temperature.
• During open-window detection mode, once the ambient temperature
drops 5-10 °C within 10 minutes, then the product will stop working
within 30 minutes and enter into stand by mode. Then press
the product.
• Press . again to turn off the open-window detection, the light.
will go off and the product will resume to previous working mode.
Below is an example to set 23 °C during open-window detection:
• When turn on at the same time for both open-window detection
and weekly program, during the OFF period of weekly program, the
product doesn't work. During the working status of weekly program,
the temperature is subject to the setting temperature of open-window
detection.
Note: - Before turn on weekly program: it must set day and time period,
otherwise the weekly default state is "00", which does not work.

CLEANING AND MAINTENANCE

• Switch off from the power supply before cleaning.
• Using a soft, moist cloth, with or without a mild soap solution, carefully
clean the exterior surface of the product.
• CAUTION: Allow the product to completely cool before handling or
cleaning it.
• Do not allow water or other liquids to run into the interior of the product,
as this could create a fire and/or electrical hazard.
• We also recommend the periodic cleaning of this appliance by lightly
running a vacuum cleaner nozzle over the guards to remove any dust or
dirt that may have accumulated inside or on the unit.
• CAUTION: Do not use harsh detergents, chemical cleaners or solvents as
they may damage the surface finish of the plastic components.
/ °C" will light on. The temperature is
to turn on
EN
23