Maxi-Cosi Priori Modo De Empleo página 11

maxi-priori-1-bw 01-05-2001
• Prior to purchase check that the seat fits properly in your car.
• Take short breaks on longer journeys so that your child has some freedom of movement.
• Set a good example yourself and always wear your seat belt.
• Tell your child that he/she should never play with the belt buckle.
Questions
Contact your supplier or importer if you wish to make a warranty claim or have any other
questions (see address list on the back of the instruction manual).
The seat belt
The Maxi-Cosi Priori should be used with a static 2-point safety belt or an automatic 3-point
safety belt provided that this has been approved according to ECE R16 or an equivalent standard.
Under no circumstances should an automatic 2-point safety belt be used.
• Your Maxi-Cosi Priori can be fitted safely on almost all the seats in the car with the existing
seat belts. However, on some seats the belts are fitted so far forward that proper installation is
not possible. If this is the case, try another seat.
• In some cases the buckle of the car belt may be too long and therefore sits too high against the
base of the Maxi-Cosi Priori. Thus, the Maxi-Cosi Priori cannot be fitted securely. If this is the
case, choose another position in the car.
Attention: see figure C2
Five positions of the Maxi-Cosi Priori (A)
The Maxi-Cosi Priori may be used in five positions: Lift the handle under the front of the seat up
and pull or push the shell forwards or backwards. Release the handle in the required position and
push until you hear a distinct click.
Installing the Maxi-Cosi Priori with a 3-point safety belt (A-B)
When installing the car seat follow the installation instructions for the 3-point safety belt
described above (under section "the seat belt").
A 3-point safety belt is shown in figure B.
Place the Maxi-Cosi Priori in the sleeping position (A) on the car seat.
Thread the seat belt between the shell and base (B1).
Fasten the seat belt in the belt buckle (B1).
The lap belt now fits under the red hooks and the shoulder belt runs from the belt buckle directly
diagonally upwards. Place the shoulder belt in the belt clamp on one side only (B2) and fasten it
(B3-1). Note! The shoulder belt is now only attached on the side of the roll-up mechanism.
Push the Maxi-Cosi Priori firmly into the car seat and pull the shoulder belt tight
(B3-2) so that there is no play between the car seat and the Maxi-Cosi Priori.
Check this!
Installing the Maxi-Cosi Priori with a 2-point safety belt (C)
When installing the car seat follow the installation instructions for the 2-point safety belt
described above (under the section "the seat belt") (C2).
A 2-point safety belt is shown in figure C.
Place the Maxi-Cosi Priori in the sleeping position on the seat (A).
Thread the seat belt between the shell and the base (C1).
Press on the Maxi-Cosi Priori and pull the belt tight so that the play between the seat and the
Maxi-Cosi Priori is minimal (C1).
Placing your child in the Maxi-Cosi Priori (D)
Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards
you (D1). Note! Do not pull on the belt pads.
13:19 Pagina 3
9