How To Hang Your Ceiling Fan - Fanimation HUGH FPS8332 Serie Manual Del Usuario

WARNING
The fan must be hung with at least 7´ of clearance from
floor to blades. (Figure 1)
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before hanging.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
It is critical that the outlet box and the screws are
securely anchored to the building structure and capable
of withstanding a load of at least 35 lbs. Failure to verify
that the screws are properly installed could result in the
fan falling. (Figure 2)
1. Securely attach the ceiling junction box acceptable
for ceiling support into the building structure. Junction
box is not supplied with the fan. (Figure 2)
2. Using the ceiling junction box screws and flat
washers, securely attach the ceiling bracket gasket with
ceiling bracket assembly to the ceiling junction box as
shown. (Figure 3)
3. Remove the two screws from the motor assembly,
retain the screws for later and loosen the remaining
screws. (Figure 4)

How to Hang Your Ceiling Fan

6
Ceiling
Floor
Figure 1
NOTE: Supply wires
omitted for clarity Figure 2
Ceiling bracket
Gasket
Ceiling bracket
Assembly
NOTE: Supply wires
Figure 3
omitted for clarity
HARDWARE USED:
#8-32
JUNCTION BOX
SCREWS
FLAT WASHER
Motor
Assembly
NOTE: Supply wires
omitted for clarity
Figure 4
No
less than
7 ft
Outlet Box
Outlet Box
x 2
x 2