Check For Leaks - Bond HYPH50061-50 Manual Del Usuario

Step 2 – Install Cylinder on the
base.
■ Put the gas cylinder in the metal stand. Make
sure the gas tank sits on the metal stand
completely. Turn the wing screw on the outer
part of metal stand clockwise to secure th e
gas tank tightly. Please see Figure 13
Step 3 –Connect the Regulator
to the gas cylinder valve.
■ Turn the cylinder valve clockwise to close the
gas supply on the gas cylinder. Se e Figur e
14
■ Screw Regulator Coupling clockwise by hand
only. Make sure it is fastened. See Figure 14

Check for leaks

Warning:
Perform Leak test outdoors only.
Never leak test when smoking.
Do not use a flame to check for leaks.
Your Patio Heater has been checked at all factory
connections for leaks. To check the connection of
the regulator/cylinder: See Figure 15
■ Make leak solution by mixing 1 part liquid dish
soap and 3 parts water.
■ Brush several drops (or use spray bottle) of
the solution onto the gas hose/regulator and
regulator/cylinder connection.
■ Turn on gas. Inspect the connections and look
for bubbles.
■ If no bubbles appear, the connection is safe.
■ If bubbles appear, there is a leak, loosen and
re-tighten this connection.
Figure 13
Figure 14
NOTE:
Whenever gas connections are loosened or
removed, you must perform a complete leak test.
Figure 15
9